L3+ status shows chip xxx error, restart it OK. But after running for a while the error appears again.

Post Q&A

HashBoard

PSU

Control board

Overclock

Downclock

Liquid cooling

Mine construction

Operation and maintenance

L3+ status shows chip xxx error, restart it OK. But after running for a while the error appears again.

@Yoda

2023-07-11 03:10

912

When the L3+ miner is turned on, there is a chip XXX error, but it gets resolved after a restart. After running for a while, the XXX error appears again, and it is not the entire board that is affected, but only several chips on the hashboard.

COMMENTS1

@Ada 2023-07-11 03:11

Try replacing the power supply and observe if the issue persists over an extended period of time.
Verify if the grounding in the mining facility is properly installed.
Check the network and power supply to ensure they are functioning correctly.
Ensure proper heat dissipation and clean dust.
Consider temporarily disabling the mining monitoring software to check if it is causing any conflicts.

Please note that it's important to follow appropriate safety procedures and consult with technical experts when dealing with mining hardware issues.