STM8 / STM32 emulator programmer stlink downloader line programming and debugging MCU supports all STM32 SWD interface debugging and SWIM debugging of STM8 or STM32 series controllers. It can provide power to target 5V and 3.3V outputs. An Aluminum alloy U disk shell is used to install the internal motherboard, which is easy to carry, safe, and reliable. The internal motherboard has a 500MA resettable fuse to protect your expensive motherboard. The outer packaging uses an anti-static bag, and the automatic sealing machine seals the package, which is safe and reliable, not afraid of static electricity and not afraid of water ingress!

Product features:

1. Support the debugging of a full range of STM32 SWD interfaces; the 4-wire interface is simple (including power supply), fast, and stable; the interface is directly marked outside the definition!

2. Support full series of STM8 SWIM download and debugging (commonly used development environments such as IAR, STVD, etc. are supported).

The supported software versions are as follows:

ST-LINK Utility 2.0 and above

STVD 4.2.1 and above

STVP 3.2.3 and above

IAR EWARM V6.20 and above

IAR EWSTM8 V1.30 and above

KEIL RVMDK V4.21 and above

3. Support automatic firmware upgrades to ensure follow-up support for the company's products. The firmware has been upgraded to the new V2.J17.S4 when leaving the factory.

4. Increase the 5V power output; the output I/0 ports are protected, so you are not afraid of damage caused by misoperation!

5. The interface uses pure copper gold-plated 2.54 pitch simple horn seat, equipped with a 20CM DuPont line, which can cope with the line sequence of different target boards and flexible wiring.

6. Use the aluminum alloy casing of the U disk to protect the main board, which is easy to carry and is not afraid of static electricity or falling.